CB-04 General JJPrise Control Board
Product Code: CB-04
3
£15.00 inc. tax
Description
CB-04 General JJPrise Control Board.
This is a range of control boards only, ideal for those that are happy to wire and solder their own LEDs but want to add some functionality to them.
This board is set up for the Star Trek Re-imagined Enterprise from the 2009 film and designed to go with the Revell kit.
The board gives you the double flash beacons. strobes and a sequenced run of the impulse and warp engines.
The board uses an ATtiny85 processor that is pre-programmed with the following outputs:
The engine sequence is as follows:
This is a range of control boards only, ideal for those that are happy to wire and solder their own LEDs but want to add some functionality to them.
This board is set up for the Star Trek Re-imagined Enterprise from the 2009 film and designed to go with the Revell kit.
The board gives you the double flash beacons. strobes and a sequenced run of the impulse and warp engines.
The board uses an ATtiny85 processor that is pre-programmed with the following outputs:
- 0 - Warp Engines
- 1 - Impulse Engines
- 2 - Strobe (0.2s/0.8s)
- 3 - Double Flash 1
- 4 - Double Flash 2
The engine sequence is as follows:
- Impulse engine on for 30 seconds
- Impulse on and half bright warp engines
- Impulse off and full bright warp engines
- back to impulse only
